I
N S T A L L A T I O N
WINDOWS INSTALLATION
Please make sure of the following before you begin installation:
If you are prompted to reboot during installation, please select No. Finish installing the rest of the
■
software, then close all open windows and reboot your computer.
The information in this guide may cover software not provided with the scanner you purchased. Please
■
disregard any information about the software not applicable to your scanner.
If your computer has AntiVirus or AntiSpyware software running, you may encounter alerts or
■
messages during installation asking you to allow the installation to proceed. Although the messages
will differ based on the software your computer is running, in each case you should allow the
installation to proceed if that option is available. Alternatively, you can turn off the AntiVirus or
AntiSpyware software before installing your scanner, but if you do, make sure to turn it back on again
when installation is finished.
If your computer is running Windows 7 or later, you may see the Windows User Account Control
■
screen asking you to confirm system changes. Click the Yes button to allow the installation to proceed.
Windows USB Driver Installation
Follow these steps to install the driver to use the scanner via a USB connection to your PC. This allows
only the logged in user to use the scanner.
1. Start Microsoft Windows and make sure that no other applications are running.
2. Turn on the scanner power.
The status light comes on and flashes indicating that the scanner is receiving power.
3. Go to
www.visioneer.com/install
4. Launch the installer once the download is complete.
User Guide
11