Table of Contents
Advertisement
remain continuously illuminated. This se-
quence will continue upon subsequent vehicle
start-ups as long as the malfunction exists.
When the malfunction indicator is illuminat-
ed, the system may not be able to detect or
signal low tire pressure as intended . TPMS
malfunctions may occur for a variety of rea-
sons, including the installation of replace-
ment or alternate tires or wheels on the vehi-
cle that prevent the TPMS from functioning
properly . Always check the TPMS malfunction
telltale after replacing one or more tires or
wheels on your vehicle to ensure that the re-
placement or alternate tires and wheels allow
the TPMS to continue to function properly.
Tire pressure indicator appears
Appl ies t o vehicles: with tire pressure mo nit oring syst em
The tire pressure indicator in the instrument
cluster informs you if the tire pressure is too
low or if there is a system malfunction.
Fig. 200 Display: underinflation warning
Fig. 201 Display: System malfunction
Using the ABS sensors, the tire pressure moni-
toring system compares the tire tread circum-
ference and vibration characteristics of the in-
dividual tires . If the pressure decreases in one
or more tires, this is indicated in the instru-
Tires and wheels
259
ment cluster with a warning symbol
[I]
and a
message
c::,
fig. 200.
The tire pressure monitoring system must be
reset via MMI each time the pressures are ad-
justed (e.g. when switching between partial
and full load pressure) or after changing or re-
placing a tire on your vehicle
c::,
page 260.
The
TPMS indicator only monitors the tire pres-
sure that you have previously stored. You can
find the recommended tire pressures for your
vehicle on the label on driver's side 8-pillar
~ page 244.
Tire tread circumference and vibration charac-
teristics can change and cause a tire pressure
warning if:
- the tire pressure in one or more tires is too
low,
- the tire has structural damage,
- the tire pressure was changed, wheels rotat-
ed or replaced but the TPMS was not reset
c::,
page 260 .
Warning symbols
[I]
Loss of pressure in at least one tire
c::>
&..
Check the tire or tires and replace or repair if
necessary. The indicator light
[I]
in the instru-
ment cluster also illuminates
c::> page 12.
Check/correct the pressures of all four tires
and reset TPMS via MMI.
i:mJ)
(Tire Pressure Monitoring System) Tire
pressure! System malfunction .
If@m
appears after switching the ignition on
or while driving
c::,
fig. 201
and the indicator
light
[I]
in the instrument cluster blinks for
approximately one minute and then stays on,
there is a system malfunction.
Attempt to store the correct tire pressure
c::,
page 260.
If the indicator light does not
turn off or if it turns on shortly thereafter, im-
mediately drive your vehicle to an authorized
Audi dealer or authorized repair facility to
have the malfunction corrected.
Advertisement
Table of Contents
