Precautions - Onkyo TX-DS898 Instruction Manual

21. Replacement Parts - When replacement parts are required, be
sure the service technician has used replacement parts specified
by the manufacturer or have the same characteristics as the
original part. Unauthorized substitutions may result in fire,
electric shock, or other hazards.
22. Safety Check - Upon completion of any service or repairs to the
appliance, ask 1he service lechnieian to perform safety checks Io
determine tha_ the appliance is in proper operation condition.
23. Wall or Ceiling Mounting - The appliance should be mounted
Io a wall or ceiling only as recommended by the manufacturer.
24. Heat - The appliance should be situated away from heat
sources such as radiatoz:s, heat registrars, stoves, or other appli-
ances (including amplifiers) that produce heat.
Precautions
FIGURE 1:
EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL
ELECTRICAL CODE, ANSUNFPA 70
(N£C SECTION 8_0 20)
3ROUNDINGCQNDUCTORS
(N£OSECTIQN81021)
NEC NAT[ONALELECTRICALCOD£ £LECTRODESYSTE M
$2898A {N£C ART 250PART H}
1. Recording Copyright
Recording of copyrighted material for other than personal use is
illegal without permission of the copyright holder.
2. AC Fuse
Re fuse is located inside the chassis and is not u_r-serviceable. If power
does not come on, contact your Onkyo aulhofized service station.
3. Care
From time to time you should wipe the front and rein" panels and the
cabinet with a soft cloth. For heavier dirt, dampen a sofi clolh in a
weak solution of mild detergent and water, wring it out dry, and
wipe off the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material, thinnez_s, alcohol or other chemi-
cal solvents or cloths since these could damage the finish or remove
the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to
country or region. Be sure that the power supply voltage of the area
where this unit will be used meets the required voltage (e.g., AC
230 V, 50 Hz or AC 120 V, 60 Hz) writlen on the rear panel.
For U.S. models
Note to CATV system installer:
This reminder is provided to call the CATV system installer's at-
tention to Section 820-40 of the NEC which provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding syslem of the building, as close
Io the point of cable entry as practical.
FCC Information for User
CAUTION:
The user changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pm:suant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if no1
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to CoITect the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
For Canadian models
NOTE:
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CA-
NADIAN ICES-003.
For models having a power cord with a polarized plug:
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Modele pour les Canadien
REMARQUE:
CET APP/_REIL NUMI_RIQUE DE LA CLASSE B EST CON-
FORME A LA NORME NMB-003 DU CANADA.
Sur les modNes dont la fiche est polaris6e:
ATTENTION:
POUR I_VITER LES CHOCS
I_LECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE
DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA
PRISE ET POUSSER JUSQU'AU FOND.
3