Listening To A Source Component.15; Adjusting The Sound.15 - Kenwood VR Series Instruction Manual

Listening to a source component
Adjusting the sound
VR/KRF-V SERIES (En/KM)
VOLUME CONTROL
Q Use the input selector (INPUT SELECTOR (AUDIO, VIDEO))
to select the source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
O
TUNER
© -CD" ("CD"*)
6 "TAPE" or "MD" ("TAPE"*)
O "PHONOTPHONO"*)
O "VIDEOI" ("VCR1 "*)
G "VIDE02" ("VCR2"*)
o "DVD 6ch"
SOURCE DIRECT VOLUME CONTROL
BASS BOO ST
SO UND
FDT'i'X
□
m
T
\
o 1
o
oil
T
I
1 «
PHONES
MULTI CONTROL
SPEAKERS A/B (KRF-6020)
SPEAKERS, MUTE (except tor KRF-6020)
VIDEO
VOLUME
TUNING/SKIP
MUTE
SOUND
VOLUME
MUTE
sound~|21|j
MULTI CONTROL n
o o a o j
RC-R0711
Adjusting the tone
The following adjustments are possible if the receiver is in the stereo
mode.
O Press the SOUND key to select the tone mode to be adjusted.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
Selecting a source using the AUDIO key
on the remote control (RC-R0608)
O "CD" ("CD"*)
G "TAPE" or "MD" ("TAPE"*)
© TUNER
© "PHONOTPHONO"*)
Selecting a source using the VIDEO key
on the remote control (RC-R0608)
O "VIDEOI "("VCR1"*)
© "VIDE02" ("VCR2"*)
© "DVD 6ch"
♦ When selecting an input source by using the remote control (RC-
R0711), press the desired input selector key.
• "VIDEO
2"
can be selected as an input source only if the VIDEO 2/
MONITOR setting is "VIDEO 2". -□£
* Once setup codes are registered in the remote control (RC-R0608),
the input name display changes according to the name of the
registered component.
Example: if you register a VCR at the VIDEO 1 jacks. 'VCR* appears
instead of 'VIDEO IV RC-1X
• When using the remote control (RC-R0608) after initial setup, any
inputs that have not been registered with a setup code are deleted
from the cyclic list. RC-QQ
♦ The INPUT SELECTOR on the front panel of the receiver always
cycles through all inputs.
•£ 3 I +w
-
© Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound
quality.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 8 seconds.
• If you used the remote control (RC-R0608) to perform the above
setting, press the VIDEO key at this point to turn off the remote
control's own adjustment mode. In this case, the input source is not
switched.
Once-touch low frequency emphasis (bass boost)
The following adjustments are possible if the receiver is in the stereo
mode.
Press the BASS BOOST key.
• Press the key once to select the maximum (+10) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
g Start playback from the selected source. Switching back to the previous setting
Press the BASS BOOST key again.
B Use the VOLUME CONTROL (VOLUME) to adjust the
volume.