LG WM6700H A Series Owner's Manual page 69

inch (1.5 cm). The dryer should be checked while
the dryer is running with no load.
Checking Levelness
Once the dryer is in its final location, recheck the
dryer to be sure it is level. Make sure it is level front
to back and side to side, and that all four leveling
feet are in firm contact with the floor.
Test Exhaust System
Once you have completed the installation of the
appliance, use this test to make sure the condition
of the exhaust system is adequate for proper
operation of the appliance. This test should be
performed to alert you to any serious problems in
the exhaust system of your home.
• Your appliance features Flow Sense
innovative sensing system that automatically
detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint
buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
NOTE
• The appliance should be cool before starting this
test. If the appliance was warmed up during
installation, run the Air Dry cycle for a few
minutes to reduce the interior temperature.
Activating the Installation Test
1
Remove the drying rack (on some models)
and literature, and then close the door.
• Do not load anything in the drum for this
test, as it may affect the accuracy of the
results.
2
Press the Power button then IMMEDIATELY
press and hold the Low Static and Options
buttons.
• This button sequence activates the
TM
, an
3
Press the Start/Pause button.
• The appliance will start the test, which will
4
Check the display for results.
• During the test cycle, monitor the Flow
• If the Flow Sense
5
End of cycle.
• At the end of the test cycle, a message will
INSTALLATION
installation test. A message will display if
the activation is successful.
last a few minutes. The heat will be turned
on and the temperatures in the drum will be
measured.
TM
Sense display on the control panel. If the
TM
Flow Sense LED has not turned on when
the cycle ends, the exhaust system is
adequate. If the exhaust system is severely
restricted, the Flow Sense
on. Other problems may also be shown with
error codes. See the chart on the next page
for error code details and solutions.
TM
LED indicates that the
exhaust system is severely restricted, have
the system checked immediately, as
performance will be poor.
display. The test cycle will end and the
25
TM
LED will turn