Haier HD80-A3939E-S User Manual page 77

drying cycle ends, if ANTI-CREASE was
previously selected the indicator will light
up. The drum will keep rotation for
another 6 hours with cold wind in.
To stop the

programme selector to OFF. Useful when
it's not possible to remove immediately
the laundry.
DELAY button
This button allows to delay the start of the

programme from 1 hour to 12 hours in 1
hour intervals. The delay selected is
shown on the display.
After pressing the START/PAUSE button the

time showed decrease minute after minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
I-TIME button
This function is designed to allow users to

adjust cycle duration based on personal
needs (can be used only on some
programmes as shown in the table of
programmes).
The progressive pressure increases the

time in 10 minutes intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off
the dryer.
DRY LEVEL button
This button allows to set the desired
dryness level. On the display is shown as
below:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Ready to Wear: to get garment ready
to be hang.
Cupboard: for laundry that can be
directly stored.
movements set
TEMPERATURE button
This button
temperature based on personal needs and
requirements. There are 3 levels and
the
matching display is shown below:
High temperature.
Middle temperature.
Low temperature.
CHILD LOCK
Pressing simultaneously the buttons "F"

and "G" for about 3 seconds, the
machine allows you to lock the keys. In
this way,
accidental or unwanted changes if a
button on
accidently during a cycle
The key lock can be simply cancelled by

pressing the two buttons simultaneously
again.
In case of opening of porthole with

activated CHILD LOCK, the cycle stops
but the lock is kept: to restart the cycle,
you must remove the lock and press
START/PAUSE again.
CHILD LOCK can be modified at any

time of the cycle.
SOUND ON/OFF
The buzzer is design to alert users with

a sound. It is deactivated by default. In
order to activate the buzzer function,
press simultaneously the buttons "D"
and "E" for about 3 seconds.
The buzzer function can be simply

cancelled by pressing the two buttons
simultaneously again.
77
is set to adjust
you can avoid
the display is
.
drying
making
pressed