Advertisement
Getting to know your Machine
KNOW YOUR MACHINE
Detergent/Fabric
conditioner drawer
Programme dial
Model
number
Adjustable feet
PREPARATION FOR USE
Push here to
Close
Door Release
and Lock
STARTING THE WASH
DURING THE CYCLE
WHEN THE CYCLE
HAS FINISHED
Mains on/off outton
Door Release
Button & Lock
(not on WM21)
` Door Release
Button & Lock
(WM21 only)
Additional Feature Buttons
Hot water
inlet Point
and hose (red)
Mains cable
Rating Plate
Cold Water
Inlet Point
CELL
moles
aS,
BH
Hose retaining
Drain hose
A typical Wash cycle eg: garments with a \40/ symbol.
Turn on the hot and cold water supplies.
Plug in and switch on the electricity. IMPORTANT: ENSURE
THAT YOUR HANDS ARE DRY.
Sort out the clothes for a \40/ wash.
Open the door by pressing in the Door Release Button.
Load your clothes into the machine (with detergent dosing
device, if required).
Push the door firmly to close.
lf children are nearby, it is recommended that you lock the door
by turning the slot to a horizontal position.
Select the programme required by turning the knob
CLOCKWISE until the correct symbol is in the 12 o'clock
position. Each wash position has a positive select point, which
can easily be detected when turning the knob slowly.
Add the detergent and fabric conditioner into the appropriate
compartments in the dispenser drawer.
Press On/Off button — (The mains neon will light up on WM21
and WM22). You will hear the sound of the water flowing into
the machine.
Your machine will wash, rinse and spin.
Your machine has a feature to prevent it spinning with a large
unbalance in the wash load
For further information see 'The Machine at Work'.
Release the On/Off button.
lf safety lock has been engaged, prior to start of wash, turn the
slot to a vertical position.
Open the door, by pressing the door release, and remove the
clothes (and the dosing ball if usea).
Switch off the electricity and water after every wash session.
Advertisement
