Table of Contents
Advertisement
4. While a second person holds the Right Handrail (85) and
the Console Base (87) near the dght Uptight (82), cut the
indicated.plestic ties off the Right Handrail. Do not cut
the other plastic'tle
off the Right Handrail. Next, cut
the plastio tie off the UPdght Wire Harness (34) in the
right Upright (82), Do not drop the Upright Wire
Hamess.i_to
_the-d_tJJprighL
Refer to the inset drawing. Connect the Updght Wire
Harness (34) to the Console Wire Harness (48). The
latch on the Console Wire Hamess should snap onto the
Updght Wire Hamess. ff the Wire Harnesses do not fit
together easily, turn them; do not force the Wire
Harnesses together. Next, connect the dght pulse wire
(with the _
tag), the left pulse wire, and the ground wire
to the corresponding connectors on the Console Wire
Harness (48); make sure that the wires with tags are
connected
to each other.
5. Nots that there is still a plastic tie in the Right
Handrail (85); do not remove this plastic tie.
Position the Right Handrail (85) on the right Updght (82)
as shown. The bracket on the base of the dght Upright
should be inside of the lower end of the dght Handrail, as
shown in the inset drawing.
While holding the Console Base (87) near the Right
Handrail (85), feed the Console Wire Harness (48) into
the Right Handrail. Next, place the Console Base on the
Handrails (74, 85). Insert any remaining Console Wire
Harness into the Right Handrail.
Thread two Handrail Bolts (78) with Handrail Washers
(36) into the Left Handrail (74) and the left Updght (82) as
shown. Do not tigh(en the Handrail Bolts yet. Next,
thread two Handrail Bolts (78) with Handrail Washers
(36) into the Right Handrail (85) and the right Updght
(82). Do not tighten the Handrail Bolts yet. Be careful
to avoid damaging the Console Wire Harness (48).
6. Attach the Console Base (87) to the Left and Right
Handrails (74, 85) with four Long Screws (114).
Refer to assembly step 5. Tighten the four Handrail
Bolts (78) used in assembly step 5.
Press two Small Upright Plugs (79) into the holes near
the upper ends of the Uprights (82).
7. Remove the backing from the Adhesive Clip (99). Press
the Adhesive Clip onto the base of the right Upright (82)
as shown. Press the Allen Wrench (100) into the
Adhesive Clip.
8. Make sure that all parts are tightened before you
use the treadmill. To protect the floor or carpet, place
a mat under the treadmill.
Ground
- Cut Plastic Tie
87
Do not
Remove
this
Plastic
Tie
36
6
87_
=..,
99
100
Advertisement
Table of Contents
