Back Panel; Speaker Systems - Denon DRA-625R Operating Instructions Manual

ENGLISH
BACK PANEL
ALBERTA THA
Comsoumma TiO
WADE 1 APA
FHPUTS
AnTENNA TERMINALS
fucer Kea cn
>)
FM ANT (FM Antenna Terminals)
75-ohms coaxial cable can be connected to this terminal.
For antenna connecting procedure, see the ANTENNA
INSTALLATION (page 7).
AM ANT (AM Antenna Terminals)
Connect the attached AM loop antenna. (Refer to page 7 for
connection).
Connect to this terminal when a medium wave outdoor
antenna is used.
GND (Grounding Terminal)
The grounding wire of the turntable is connected here.
e Hum or noise may be generated if the grounding wire is
not connected.
TAPE/REMOTE CONTROL
This terminal is exclusively used for sending the remote
control signals to the tape deck. Connect it with a 3.5mm
mini-jack cord.
Note:
Do not hook up a headphones or microphone jack
cord. Use this jack to connect a Denon cassette deck
with a remote control jack (wired).
If the cassette deck does not have this jack, wired
remote control is not possible.
PHONO (Phono Input Terminals)
The output cord of the turntable is connected here.
Since the input sensitivity of "PHONO" is extremely high,
do not use the unit without the input pin cord. If used
without this cord, the speakers may generate hum.
CD
The output cord of the CD player is connected here.
AUX/VIDEO
An AUX/VIDEO, such as a VCR or Video Disk may be
connected here.
TAPE-1, TAPE-2 (Audio Playback and Recording
Terminals)
Tape decks can be connected for full use including paying
or copying.
'WARNING: SHOCK MAZARD-O NET #PEW.
AYIS > MISHUE BE CHOC ELECTRIQUE ELECTRIC SHOCK, O8 MOT EXPOSE THIS
WE PAS BUTRIE, APPLIANCE TO RAIN OR MOISTURE. (a)
® SPEARER SYSTEMS
;
-
'WARMING: Te REDUCE TE miSK OF FRE OR
heh: &~lbobm /SPEARER
A+O: 12~ 1 Gobm /SPEARER
e @
DRA-625R only
PRE-OUT (DRA-625R only)
Output signals for power amplifiers are sentfrom these
jacks. The rated output is 1.0 volts.
The signals do not pass through the bass and treble
circuits.
SPEAKER SYSTEMS (Speaker Terminals
The matching impedance of this amplifier is 6 cams. Either
one or two pairs of speakers may be connectec If only pair
is connected the recommended speaker impedince may be
anywhere between 6 and 16 ohms. If twe pairs are
connected, however, it is advisable to use spexers with at
least an 12 ohms impedance for optimum performance.
Connecting two pairs of 6 ohms speakers isnot recom-
mended.
AC CORD (Power Cord)
Connect this cord into the wall outlet.
AM LOOP ANT (AM Loop Antenna)
Correctly connect the AM loop antenna to te antenna
terminal. Broadcasting cannot be received wren the con-
nection is incomplete.
Adjust the antenna for optimum reception whle receiving
the medium wave broadcasting. Do not place a»in cord, SP
cord or electric cord near the antenna. This may cause
noise generation.
Note:
e Two FM antennas should not be cannected
simultaneously.
e Even if an external AM antenna is usedthe AM
loop antenna should not be disconneced.
e AM loop antenna lead terminals do not fuch the
metal part of the back panel.