Hitachi 46F510 Operating Manual page 22

HOW TO USE THE REMOTE TO
CONTROL YOUR TV
(_ VOLUME, MUTE button
Press the VOLUME up (_,) or down (T) button until you obtain the desired sound level.
To reduce the sound to one half of normal volume (SOFT MUTE) to answer the telephone, etc, press the MUTE button. Press the
MUTE button again to turn the sound off completely (MUTE). To restore the sound, press the MUTE button one more time, or press
the VOLUME Up (A) button.
MUTE MUTE
Closed Captioning wiII display when MUTE/SOFT MUTE is on and Closed Caption is set to AUTO (See page 58).
(_) CHANNEL semector buttons
CHANNEL selector buttons are used to select channels, Iock access code, etc.
Enter one, two, or three numbers to select channels. Enter "0" first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the "1" button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
iiiiiiiiiiiiii!!
iiiiiiiiiiiiiiii'_i_!ilZ_:!ii!!,ii!i
iiiilililililililiiii_!!:!!:!!:!!i!_i_!!
iiiiiiiiiii iiiiiii! i
iiiiiiiiiii iiiiiii! i i i
iiiiiiiiiii_!!!!!!!!!!_!_!_!!i
Channel selection may also be performed by pressing CH up (,L) or down (V).
NOTE: The TV not receive channels if not in the correct ANTENNA/CABLE mode 41
may
some
you
are
(see page
).
ANTENNA button
The ANT button will select between Antenna A and Antenna B each time the button is pressed.
(_} VlD1 ~ WD5
When the remote control is in TV mode, press these buttons to directly select the video input sources between the five video inputs.
When the remote control is in Set-Top-Box mode (STB) these buttons will control the Set-Top-Box or satellite receiver, and execute
the secondary function labeled.
YPBPR:II
22