Cleaning and user maintenance shall not be made by children without supervision 5. Only Hoover recommended tools and accessories should be used with this Floormate 6. Don’t use this Floormate if it has been dropped, damaged, immersed in water or left outdoors 7.
OPERATION Please read General Safety Information at the beginning before use. Assembling your steam mop Raise handle to upright To lower handle, press To install brushes rest the machine on the position until it locks handle release button floor. Align the post on the spin brushes into place and fold handle to with the square hole...
Page 6
Please remove any large objects or debris prior to using your Floormate Trio. IMPORTANT: Only use Hoover hard floors cleaning solution. Using other solutions may cause excess foaming. Excessive foam will prevent the machine from working effectively. Using other solutions will invalidate the guarantee...
Page 7
OPERATION Emptying the recovery tank NOTE: The recovery tank has an automatic shut off to prevent the tank from overflowing. If this is activated, the machine will not pick up and the sound of the motor will change. The recovery tank will need to be emptied To remove recovery tank, Remove recovery tank lid press down on release...
Page 8
OPERATION Using your machine The machine can also be The mode selector allows you to moved by lifting the machine choose DRY VAC, WASH or WET using the carry handle on PICKUP. For dry debris pick up turn the front the dial to DRY VAC, the brushes will not rotate To wash hard floors turn the...
MAINTENANCE 40˚C 40˚C The clean water tank contains a washable filter. Clean this filter Rinse under water to remove when suction is low. Pull open the filter lid gently to remove the debris (max. 40°C) and leave filter for cleaning for at least 24 hours or until fully dry before replacing in the machine...
Page 10
MAINTENANCE Cleaning the nozzle Nozzle can be removed Remove nozzle by pulling Remove any debris from for easy cleaning. Slide straight out and rinse under squeegee by wiping with the two nozzle release running water (max. 40°C) a damp cloth latches outwards Cleaning the brushes Push both brush release...
FAQs Why won’t my Floormate switch on? • Check the fuse in the plug. Always replace the fuse in the plug with a 13amp fuse Why won’t my Floormate pick up? • Empty recovery tank, remove any debris from filter. If washing filter allow 24 hours to fully dry before refitting •...
Other Information Service & Help If you have queries or concerns about using your Hoover, please visit www.hoover.ae Technical Specification Voltage: 220-240V ~50/60Hz Wattage: 700W Cord length: 6m (approx) Weight: 7.3 kg (approx) Subject to technical change without notice. EEC Statement of Compliance...