Table of Contents
Advertisement
R
6.1 SELF-PROPEL DRIVE ADJUSTMENTS
An adjustment to the self-propel system should be made
whenever a new cable is installed.
SPEED SELECT CONTROL CABLE
ADJUSTMENT
1. Shut the engine off and wait for all moving parts to
stop.
2. Disconnect the spark plug wire from the spark plug.
3. If the grass catcher bag is installed, remove it from
the mower.
4. Using a piece of scrap material, broom handle or
other object wider that the handle bars, lift and
support the rear cover to gain access to the rear of
the mower. See Figure 6-1.
Figure 6-1. Lift and Support Rear Cover
5. Remove the two bolts securing the transmission
access cover to the mower.
6. Remove the transmission access cover and remove
any debris that has collected on the transmission.
See Figure 6-2.
ADJUSTMENTS
SUPPORT REAR COVER
CONTROL ARM
Figure 6-2. Transmission Access
7. Loosen the clamp securing the speed select cable to
the transmission. See Figure 6-2.
8. Move the speed select control all the way back. See
Figure 6-3.
22
Section 6
REMOVE COVER
LOOSEN HERE
Advertisement
Table of Contents
