Advertisement
Available languages
Available languages
Install the front leveling feet
1. Prop up the front of the washer/dryer about 4" (10,2 cm) with
a wood block or similar object. The block needs to support
the weight of the washer/dryer.
2. Screw the Iocknut onto each foot to within 1" (2.5 cm) of the
base.
1 "
(2.5 cm)
t
......
J
3. Screw the feet into the correct holes at the front corner of the
washer/dryer until the nuts touch the washer.
NOTE: Do not tighten the nuts until the washer/dryer
is level.
4. Tilt the washer/dryer
back and remove the wood block, Gently
lower the washer/dryer to the floor.
For mobile home use
Washer/dryers with gas dryers must be securely fastened to the
floor.
Mobile home installations
require a Mobile Home Installation
Kit.
See "Tools and Parts" section for information
on ordering.
Proper connection of the drain hose protects your floors from
damage due to water leakage. To keep the drain hose from
coming off or leaking, it must be installed according to the
following instructions:
IMPORTANT: To ensure proper installation, this procedure must
be followed exactly.
1. Check the drain hose to see whether it is the proper length.
2. Wet the inside of the straight end of the drain hose with tap
water.
IMPORTANT: Do not use any lubricant other than wate£
3. Squeeze ears of the silver, double-wire
clamp with pliers to
open. Place clamp over the straight end of the drain hose
1A" (6.4 mm) from the end,
(6.4 rnm)
4=
Open clamp, Twist hose back and forth while pushing onto
drain connector on the side of the washer/dryer. Continue until
hose contacts the ribbed stops on the cabinet.
5. Place clamp over the area marked "CLAMR" Release clamp.
For laundry tub or standpipe
drain systems
1. Make sure drain hose form is in correct position.
A. Drain hose form
2. Put hooked end of drain hose into laundry tub or standpipe.
Rotate hook to eliminate kinks.
To keep drain water from going back into the washer:
•
Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for air.
•
Do not lay excess hose on the bottom of the laundry tub.
For use with floor drain
Do not install the drain hose form onto the corrugated drain hose,
You may need additional parts. See Floor drain under "Tools and
Parts."
Insert a new flat washer into each end of the inlet hoses.
Firmly seat the washers in the couplings.
A
B
A. Coupling
B. Washer
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1. Attach hose to the hot water faucet. Screw on coupling by
hand until it is seated on the washer.
2. Attach hose to the cold water faucet. Screw on coupling by
hand until it is seated on the washer.
Advertisement
