GE JVM3150 Installation Instructions Manual page 21

Installation Instructions
ADAPTING BLOWER FOR
RECIRCULATION (continued)
Place the blower unit back into the opening.
ACAUTI ON: Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
C3.
[6 | Replace blower plate and replace screws for blower
plate and blower motor removed in Step 1.
Blower Plate Screws
Blower Plate
Back of
FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE
RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent cutting
of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening
screws.
21
NOTE: When mounting the
oven, thread power cord
through hole in bottom of
top cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift oven
by pulling cord.
Lift oven, tilt it
forward and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
\
Sissage \ '
Rotate front of oven up
against cabinet
bottom.
Cabinet Front
SJ, Cabinet Bottom Shelf
/ Filler Block
Le T wi
"Ni
@—— Self-Aligning Screw
Equivalent to Depth
of Cabinet Recess
Oven Top