Watchguard SSL 1000 User Manual page 32

Installing the Firebox SSL VPN Gateway for the First Time
• [4] Display Log displays the Firebox SSL VPN Gateway log
• [5] Reset Certificate resets the certificate to the default certificate that comes with the Firebox
SSL VPN Gateway
• [6] Change Administrative Password allows you to change the default administrator password
of rootadmin
Important: WatchGuard recommends changing the administrator password before connecting the
Firebox SSL VPN Gateway to your network. The new password can be six to 127 characters long and
cannot begin or end with a space.
• [7] Help displays help information
• [8] Log Out logs off from the Firebox SSL VPN Gateway
WatchGuard recommends using both network adapters on the appliance. After configuring the TCP/IP
settings for Interface 0, use the Administration Tool to configure TCP/IP settings for Interface 1.
onfigure TCP/IP settings using a serial cable
To c
1 Connect the serial cable to the 9-pin serial port on the Firebox SSL VPN and connect the cable to a
computer that is capable of running terminal emulation software.
2 On the computer, start a terminal emulation application such as HyperTerminal.
HyperTerminal is not automatically installed on Windows 2000 Server or Windows Server 2003. To install
HyperTerminal, use Add/Remove Programs in the Control Panel.
3 Set the serial connection to 9600 bits per second, 8 data bits, no parity, 1 stop bit. Hardware flow
control is optional.
4 Turn on the Firebox SSL VPN. The serial console appears on the computer terminal after about three
minutes.
5 If using HyperTerminal, press the Enter key.
6 On the serial console, enter the default administrator credentials. The user name is root and the
password is rootadmin.
Important: Watchguard recommends changing the administrator password. You can do this using the
Administration Portal or the serial console.
7 To set the IP address and subnet mask and the default gateway device for Interface 0, type 0 and
press Enter to choose Express Setup. After you respond to the prompts, the information you
entered appears. To commit your changes, type y; the Access Gateway restarts.
8 To verify that the Firebox SSL VPN can ping a connected network device, type 1 and enter the IP
address of the device.
9 Remove the serial cable and connect the Firebox SSL VPN using either a cross-over cable to a
Windows computer or a network cable to a network switch and then turn on the Firebox SSL VPN.
Additional Firebox SSL VPN settings are configured using the Administration Tool.
22
Note
Note
Note
Note
Firebox SSL VPN Gateway