Removing line cards
The Firebox V200 has two line cards, which are installed from the front
side of the appliance. These cards are not redundant or hot-swappable.
You must complete a system shutdown in CLI or Vcontroller and turn off
the appliance before you replace the line cards. For more information on
completing a system shutdown, see the Firebox Vclass User Guide. Do not
remove the defective line cards until a replacement is available. The
following figure shows an assembled Firebox V200 appliance.
To remove a line card:
1
10
Shut down the system and turn off the power supply switch located
on the back of the appliance. For more information on system
shutdown, see the Firebox Vclass User Guide.
WatchGuard Firebox V200