Table of Contents
Advertisement
Remove theclickpinthatsecures theleftwheel t o
theaxleandslide thewheel f romtheaxle.
Remove thefourscrews securing theleftdrive
covertotheframe.Remove t hedrivecover. S ee
Figure 16.
Drive
Cover
Scre',_.
_Left Axle
Cover
Figure 16
Holding the friction wheel assembly, slide the hex
shaft out of the left side of the frame. The spacer on
the right side of the hex shaft will fall and the
sprocket should remain hanging loose in the chain.
See Figure 17.
Shift Rod
Assembly
Friction
Assembly
Figure 17
Lift the friction wheel assembly out between the
axle shaft and the drive shaft assemblies.
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plates. See Figure 18.
Reassemble the new friction wheel rubber to the
friction wheel plates and hub, tightening the six
screws in rotation and with equal force.
Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the hex shaft
through the friction wheel assembly. Reassemble
in reverse order.
Screws
Friction Wheel Rubber
Hub
Screws
Friction Wheel
Plates
Figure 18
0ff-seas0n Storage
WARNING:
Never store the machine
or
fuel container
indoors where there is an
open flame, spark, or pilot light such as on
water
heater, furnace,
clothes
dryer, or
other gas appliance.
WARNING:
Drain fuel into an approved
container
outdoors,
away from
an open
flame. Allow engine to cool. Extinguish
cigarettes,
cigars,
pipes,
and
other
sources of ignition prior to draining fuel.
Fuel left in engine for extended
periods
deteriorates
and
will
cause
starting
problems.
If unit is to be stored over 30 days, prepare for storage
as follows:
Remove gasoline from carburetor and fuel tank to
prevent gum deposits from forming on these parts
and causing possible malfunction of engine.
Run engine until fuel tank is empty and engine
stops due to lack of fuel.
Drain carburetor by pressing upward on bowl drain,
located below the carburetor cover.
NOTE: Fuel stabilizer is an acceptable
alternative
in
minimizing
the formation of fuel gum deposits during
storage. Do not drain carburetor if using fuel stabilizer.
Wipe equipment with an oiled rag to prevent rust.
Remove spark plug and pour one ounce of engine
oil through spark plug hole into cylinder. Cover
spark plug hole with rag. Crank engine several
times to distribute oi1.Replace spark plug.
Follow the lubrication recommendations
found in
the Maintenance Section.
Always store the snow thrower in a clean, dry area.
NOTE: When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rust proof the equipment.
Using a light oil or
silicone,
coat the equipment,
especially
any chains,
springs, bearings and cables.
14
Advertisement
Table of Contents
