3.
Wrap the ribbon onto the ribbon rewind
spindle. Keeping the ribbon flat and without
wrinkles.
Ribbon rewind
spindle
4.
Wind the ribbon clockwise about 3~5
rotations onto the ribbon rewind spindle until it
is smooth and properly stretched.
5.
Close the print head mechanism making sure
the latches are engaged properly.
Print head
mechanism
Loading path for ribbon
Loading Media
1.
Lift open printer right side cover. Push the
print head release lever to open the print
head mechanism.
Print head
release lever
2.
Move the label roll guard horizontally to the
end of label spindle then flip down the label
roll guard.
3.
Place the roll of media on the label supply
spindle. Flip up the label roll guard. Move the
label roll guard horizontally to gently fit the
width of label roll.
Flip up label roll
guard.
4.
Pull label roll leading edge forward through
the media guide bar, damper, media sensor
and place the label leading edge onto the
platen roller.
Media guide bar
Media sensor
Platen roller
5.
Adjust the label guide to fit the width of the
label.
Label guide
6.
Close the print head mechanism making
sure the latches are engaged properly.
Print head
mechanism
Loading path for media
7.
Using the front display panel, set the
media sensor type and calibrate the
selected sensor.
Note: Please calibrate the gap/black mark
sensor when changing media.