Onkyo TX-8211 Instruction Manual page 21

Using TAPE-2 MONITOR
Unless the component connected to the TAPE-2 connectors is to be used, the [T-2 MONITOR J indicator in the main unit's display should not
be lit; otherwise, the sound from other sources cannot be heard.
If a 3-head tape deck is connected to the TAPE-2 connectors, TAPE-2 MONITOR can be used to monitor the recording.
NOTE:
Even when TAPE-2 is not selected as the source (ihe [T-2 MONITOR J indicator is not lil), the source signal is still sent to the TAPE-2 output.
_ Monitoring during recording :
The source signal can be monitored
through the speakers or headphones
when TAPE-2 MONITOR is turned off.
na bata — I the indicator in the dis-
play is not lit, the sound from the source
[_¢ [ can be heard. If the 3-head tape deck con-
+ F nected to the TAPE-2 connectors is used
for recording, press either the TAPE-2 but-
ton on the remote control or the TAPE-2
MONITOR button on the main unit to
make "TAPE-2" appear in the display for a
few seconds, light up the
indicator, and hear the sound that is just
'recorded,
To return to listening to the source sound,
TX-8211
press either the TAPE-2
button on the
remote control or the TAPE-2 MONITOR
button on the main unit) and the
T-2 MONITOR } indicator poes off.
OPO!
T-2 MONITOR
Playback Recording Playback
k
tee CD player, etc.
or Graphic Equalizer
Shee MEOR
_Using a 'graphic equalizer. saa
1, Connect the graphi¢ equalizer to the
TAPE-2 connectors on the rear panel
of the TX-8211.
2. Ifa second tape deck is used, connect
it to the tape deck connectors on the
graphic equalizer.
remote control or the TAPE-2 MON-
ITOR button on the main unit.
The indicator on the
main unit's display lights up.
Follow the operating instructions for
the graphic equalizer,
'To record an equalized signal, use the
tape deck connected to the equalizer.
=
21