Onkyo TX-8211 Instruction Manual page 16

Receiving stations
FM MUTE,
Sorr<
APR
STEREO
MODE
110
If you tune in a stereo FM station, the STEREO indicator will be
illuminated if the signal is sufficiently strong.
If the signal is weak, it may be impossible to tune into your
desired station, In this case, tune in as follows.
Press the FM MUTE/MODE button and FM MUTE OFF lights up.
At this time, the station will be in mono and interstation noise will
be heard.
Select the station you want to listen to.
This unit is equipped with an APR system to help tune in FM sta-
lions.
When receiving an FM station using manual or direct tuning, RF
MODE LOCAL/DX and STEREO MODE AUTO/MONDO settings
ave made automatically, according to the station being received.
The APR system automatically sets the gain of the RF section to
DX or LOCAL according to the quality of the signal being
received. The RF MODE will indicate LOCAL when a sufficient
signal is received.
If the MONO indicator fights up while a station is tuned in, the
station will be received in mono even if it is a stereo station.
The STEREO MODE AUTO/MONO settings that the APR system
makes can be changed by pressing the FM MUTE/MODE button,
etl attr ~ - 7 od
pared a oegey
- Programming fi fadlo stations "9
Se eR i es oa
Since ten AM or FM stations can be stored
in each group (A, B or C), a total of 30 sta-
tions can be stored in the memory.
- Select the frequency that you want to
store in the memory.
MLMADRY FAA ULITE MOE
@
tT ba
ri
UAE ® TUNED 4, MEMORY, EU
(Refer to "Tuning the radio" on page
15.)
. Press the MEMORY button.
The MEMORY indicator will light for
8 seconds.
3. While the MEMORY indicator lights,
tv
Pmt > heeo ¢
o1640 press the GROUP button to choose
mi ig the desired group.
tft
The group shown on the display
changes in the following order each
time the button is pressed: A > B > C
A...
4. Select the desired memory num-
ber using the number buttons,
Press button 0/10 when choosing mem-
ory number 10.
NOTE:
ie "sume * MOR EE If the FM station received is an RDS sta-
lion with a PS (Program Service Name),
the frequency display will change to the PS
display. If there is no PS, the frequency
display will not change.
(Refer to pages 18 and 19 for more details
on the RDS function.)