Skoda Octavia III 2013 Workshop Manual page 41

– To so do, turn the plastic feet under the calibration plate until
the air bubble in the spirit level is exactly in the middle of the
indicator -arrow-.
Caution
Light is reflected by the calibration plate!
If the calibration plate is e.g. under windows or the door is open,
reflections interfere with image recognition by the rear view
camera - R189- and it may not be possible to perform calibra‐
tion.
In this case, you must prevent dazzle on the side of the plate
by e.g. screening or closing the door.
– Switch on the linear laser - VAS 6350/3- Pos. -1- on the cali‐
bration plate and align the entire calibration device - VAS
6350- so that the laser beam -2- is pointed on the centre of the
rear of the vehicle over the Škoda badge.
Next - calibrate the rear view camera - R189-
⇒ "7.4.2 Calibrating the rear view camera R189 ", page 37
7.4.2 Calibrating the rear view camera - R189-
Special tools and workshop equipment required
♦ Calibration device - VAS 6350- / -VAS 6350A-
♦ Distance laser - VAS 6350/2- / -VAS 6350/2A-
– Establish correct conditions
– Connect ⇒ Vehicle diagnostic tester.
Attach wheel centre support - VAS 6350/1- to the rear axle.
– Check the circle diameter of the wheel rims.
– Fit the wheel centre support - VAS 6350/1- .
– To do so, attach three adapters for the wheel bolts on the
wheel rim to each wheel centre support - VAS 6350/1- .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
⇒ page 35 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
.
37
7. Rear view camera