How To Program The Player To Pause Or Scan Automatically - Sony MDP-600 Operating Instructions Manual

How to Program the Player to Pause or Scan Automatically
There are many functions you can program the Multi Disc Player to do automatically. Two of them are Auto Pause and
Intro Scan. To make the player stop every time a selection ends, use Auto Pause. When you want to find a particular
track, use the INTRO button to make the player play the first 8 seconds (approximately) of each chapter or track on the
CD, LD, or CDV. Locate the AUTO PAUSE and INTRO buttons on the Remote Commander.
To display "A. PAUSE" on the TV screen, press
DISPLAY twice. If you have pressed DISPLAY
once, "A. PAUSE" appears for three seconds,
then disappears.
T- 2 4-1 0:10 PLAY
AUDIO. 1-10 40:29
2 3
? 8
1 4 §
6 9 10
AUTO PAUSE
To Resume Normal Playback .... Press AUTO PAUSE again.
To Scan the Beginning of Each INTRO
Press INTRO on the Remote.
The player plays only the first 8 seconds
Chapter/T rack (Intro Scan) iia Cal (introduction) of each chapter or track on the
disc.** When playing an LD, the player pauses
after introducing the last chapter on side B of
the disc. If nothing is recorded on side B, the
player stops at the end of side A. On CDVs,
intro-scanning resumes from the video section
of the disc.
CLEAR
To Resume Normal Play ..........
(|
Press CLEAR.
STOP
Lay
Play resumes from the selection just introduced.
* In Single Repeat mode, the same selection starts playing again. In Repeat A-B mode, playback starts from the point
marked "A".
** In stop mode, intro-scanning starts from the first chapter or track on the disc. If you press INTRO while playing a
chapter or track, scanning starts from the next one. If you press INTRO while the player is introducing a chapter or
track, the scanning skips to the next one.
To Play Any Disc 37