Enable Graphic Mode - Custom Audio Electronics DPT100-S Command Manual

0x11

Enable graphic mode

Valid for DPT-S 24 characters per line
DPT-S 40 characters per line
[Format] Hex
ASCII
[Range]
[Description] Enables graphic mode:
a line in 24 column mode corresponds to 144 horizontal dots divided into 24 blocks of 6 dots each;
a line in 40 column mode corresponds to 240 horizontal dots divided into 40 blocks of 6 dots each.
[Notes] • To obtain graphic printing, enter the command 0x11 at the beginning of each line.
• The format of the byte in graphic coniguration is:
X
D7
where:
X
R
P1...P6
The P6 bit of the string of dots transmitted is printed on the left and the others follow from left to right
(P5, P4, P3, P2, P1) as shown:
1st byte è ►
P6 P5 P4 P3 P2 P1
[Default]
[Reference]
[Example] To print a line of dots, the command sequence is:
0x11, n x 0x7F (where n is the number of characters per line), 0x0D.
To print an empty line, the command sequence is:
0x11, 0x40, 0x0D
11
DC1
R P6 P5 P4
D6 D5 D4 D3
is not used (0 is recommended);
must be ixed at level 1;
are the graphic dot data (1 prints, 0 does not print).
2nd byte è ►
P6 P5 P4 P3 P2 P1
P3 P2 P1
D2 D1 D0
3rd byte è ►
P6 P5 P4 P3 P2 P1
<DC1>
Emulazione CUSTOM/POS
│ 27