The Prosense Load Detection - AEG L6FBG51470 User Manual

The drain pump can operate shortly before the appliance fills
water.

13.8 The ProSense load detection

The programme duration in the display is referred to a medium/
high load.
1. The appliance detects the load in the first 30 seconds: the
indicator
2. At the end of the load detection, the indicator
time dots stop flashing. The programme duration will be
adjusted accordingly and could increase or decrease. After
further 30 seconds, the water filling starts.
In this case, for 30 seconds, it is possible to pause the appliance
and remove the exceeding garments.
Once removed the exceeding garments, touch the Start/Pause
button to start the programme again. The ProSense phase can be
repeated up to three times (see point 1).
Important! If the laundry amount will not be reduced, the washing
programme starts anyway, despite the overload. In this case, it will
be not possible to guarantee the best washing results.
About 20 minutes after the programme start, the programme
duration could be adjusted again depending on the capacity of
water absorption of the fabrics.
The ProSense detection is carried out with complete washing
programmes only (no skipping phase selected).
and the time dots flash, the drum rotates shortly.
DAILY USE
goes off and the
39/68