Use With An Entire Pa System Uu; Use In The Afb Mode; With A Number Of Microphones; Powerup And Standby - Roland AP-700 Owner's Manual

Use with an Entire PA System
When using the AP-700 with all of the equipment that is
connected to the mixer, connect the output from the mixer
to the AP-700.
Speakers
Use in the AFB Mode with a Number of
Microphones
Mix all of the microphones with a small mixer before they
connect with the AP-700.
ini
-
= "Bower Amplifier
Speakers
Powerup and Standby
Switching On the Power
First check the connections with the external equipment,
and then switch on the AP-700.
The display flashes, and the AP-700 returns to the state in
effect when the power was last switched off.
Ea EDIT
SS PEAKE -~- Hz Cidid: 4/4]
FILT|
i]
-12
"24
100 200
S00 ik @k Sk 10k 20k
*
Adjust the volume for the amp after switching on all other
equipment.
*
To protect its internal circuitry, the AP-700 will not func-
tion for a short while after the power is switched on.
.
When the power is not on, signals input to the AP-700 are
output without change.
*
The display may be hard to make out when installed in cer-
tain positions. If this is the case, adjust the contrast of the
display (p. 22).
Adjusting the Input Level
The INPUT LEVEL knob should normally be left at "O" dur-
ing use. The "0" position is for uni-gain, so the input and
output levels will be identical.
You will need to use the INPUT LEVEL knob to adjust the
input level if the "OVER" segments in the level indicator
light up, or if the input level is too low.
C) Roland Ar-700 ADVANCED EQUALIZING
INET Level L INPUT A
* The input levels for the left and right channels can be set
independently.