If You Think There May Bea Problem, Check Here First; List Of Display Messages - Roland AP-700 Owner's Manual

if You Think There May Bea
Problem, Check Here First
if no sound is produced, or if you think operation may be
strange, then first check the points described here. If this
doesn't clear up the problem, then go ahead and contact
the store where you purchased the AP-700 or your nearest
Roland Service Station.
There's No Sound or Sound Is Too Low
* Is the other equipment connected correctly?
* Is the connected amp or mixer turned on, and is the
volume turned up high enough?
* Is the INPUT LEVEL knob turned up high enough?
¢ Is the Mute function switched off?
¢ Could there be broken elements inside the connection
cables?
Try replacing the connection cables.
Sound Is Distorted (The "OVER" Reading on the
Level Meter Lights Up)
Is the INPUT LEVEL knob at an appropriate setting (p.
8)?
¢ Could the output level of the external equipment be
too high?
e Is the sound still distorted when you change Patches?
if the distortion disappears when the Patch is
changed, check the settings for the first Patch.
Patches Don't Change As Expected
* Are the two devices set to the same MID! channel?
if the Patch changes to the wrong one, check the set-
tings for the Program Change Map (p. 24).
List of Display Messages
Shown below are the messages that may be displayed dur-
ing operation of the AP-700.
[SEPA] (EDIT) BERN
————— AUTOPFILTER LIMIT
100 200 S08 ik & Sk 10k 20k
The Auto function requested a setting that is beyond the
capacity of the filter (compensation over ~40 dB is
required).
AUTC EDIT
——= AUTOMNO REST FILTER
FILT,
i00 200 500 ik & Sk iDk 20K
A request was made for more filters than the reserved num-
ber.
(RFR) EDIT) EEN
FLT AUTORFILTER CLEARED! _
"12
100 200 «S00 ik & Sk 10k 20k
The [CLEAR] button was used to clear the filters of the
Auto function.
(GREH) (EOTT) EE
———— DYNAFFILTER LIMIT
"43
24
io 200
500 ik & Sk 10k 20K
The Dynamic function requested a setting that is beyond
the capacity of the filter (compensation over -40 dB is
required).
AFE (FH) EOTT) MSE
FLT DOYNGFFILTER CLEARED! _
o
"12
i100 200
S00 ik ak Sk 10k 20k
A Dynamic Off was issued, clearing the filters of the
Dynamic function.
27