Table of Contents
Advertisement
Delay
On the AP-700, each channel is provided with a delay for
sound field compensation. These delays are common to all
modes, and each delay has a maximum delay time of 411
msec (140 m). The delay time can be set as either a time or
a distance value. Here's how to make the settings for this
parameter.
{L CH: Left Channel] (0 cm to 140 m/0
to 411 msec)
MENU > SYSTEM P DELAY >
This sets the delay time for the left channel.
[R CH: Right Channel] (0 cm to 140 m/0 to 411 msec)
MENU > SYSTEM > DELAY >
This sets the delay time for the right channel.
Displaying the Software Version
This displays the version number for the AP-700's software.
MENU >» SYSTEM >» INFORMATION >
Displaying Temporary Information
This displays what is currently in operation. Information on
the following items is displayed.
MENU > SYSTEM > INFORMATION >
Original Patch Number
Patch Name
Whether edits have been performed
Comments
Adjusting the Contrast of the Display
The display may occasionally become difficult to make
out, depending on how and where the AP-700 is installed.
if the display is hard to read, this parameter can be used to
adjust the contrast (brightness).
[CONTRAST] (1 to 100)
MENU > SYSTEM >
This adjusts the contrast of the display.
22
Initialize
This initializes the settings for the AP-700.
MENU P SYSTEM > INITIALIZE >
1. Move the cursor to what you want to be initial-
ized.
ALL:
Initializes all settings. The settings return to the
same values they had when shipped from the facto-
ry.
SYSTEM:
Initializes the settings for system parameters.
TEMP:
Initializes the settings for the mode that is currently
in operation.
2. Use the (VALUE) buttons to select what you want
to initializes.
3. Move the cursor to "EXEC" (execute) and press
(ENTER).
A message appears to confirm the ini-
tialization. Press (ENTER) to initialize the settings.
If you want to start over, move the cursor to
(CANCEL) and press (ENTER).
Advertisement
Table of Contents
