Specifications - Peavey BASIC 60 Operating Manual

SPECIFICATIONS
POWER AMPLIFIER SECTION
Rated Power & Load:
50 W RMS into 8 ohms with
DDT™ compression and LED
indicator
Power At Clipping: (typically
5% THD, 1 kHz, 120 VAC
line)
57 W RMS into 8 ohms
Frequency Response;
+0. -2 dB, 60 Hz to 10 kHz at
50 W RMS into 8 ohms
Total Harmonic Distortion:
Less than 0.2%, 100 mW to
50 W RMS, 60 Hz to 10 kHz.
8 ohms; typically below 0.1%
DDT M Dynamic Range:
Greater than 16 dB
DDT™' Maximum THD:
Below 0.5% THD for 6 dB
overload
Below 1% THD for 16 dB
overload
Hum & Noise:
Greater than 90 dB below rated
power
Power Consumption:
(Domestic)
150W, 50/60 Hz, 120 VAC
Preamp Section:
The following specs are measured @ I kHz
with the controls presel as follows: Push
Bright Off (Out): Post Gain @ 10; Low LQ
@ 10; Mid EQ @ 0; High EQ @ 10; Presence
EQ @ 5; Nominal Levels are set with Pre Gain
@ 5; Minimum Levels are set with Pre Gain
@
10
.
Preamp High Gain Input:
Impedance: High Z, 220 K ohms
Nominal Input Level: -24 dBV,
60 mV RMS
Minimum Input Level: -46 dBV,
5 mV RMS
Maximum Input Level: +6 dBV,
2V RMS
Preamp Low Gain Input:
Impedance: High Z, 44 K ohms
Nominal Input Level: -18 dBV,
120 mV RMS
Minimum Input Level: -40 dBV,
10 mV RMS
Maximum Input Level:
-hl2 dBV. 4 V RMS
Preamp Output:
Load Impedance: 10 K ohms or
greater
Nominal Output: 0 dBV,
1 V RMS
Power Amp Input:
Impedance: High Z, 22 K ohms
Designed Input Level: 0 dBV,
1 V RMS
System Hum & Noise At
Nominal Input Level: (20 Hz
to 20 kHz, unweighted)
74 dB below rated power
Equalization:
Low, Mid, High, & Presence
Passive Type EQ
Bright: +6 dB at 2 kHz