Operatingexternal Componentswith The Remote Control; Operatingthe Tv; Operatingthe Dbstuner Or Catvconverter - JVC TH-C7 Instructions Manual

Operatingexternal componentswith the remote control
The buttons described below are used on pages 14 and
15.
TV/VIDEO -
VCR =
TV VOL +/- ,-
CHANNEL +/- -
•=
REC -
TV RETURN =
TV/V_DEO
TV VCFgDB_
O0 =
00"-"'"00
VOR DB8
0 ©
TVVOL CHANNEL
VCR,DBS
= Remote control
mode selector
o ll,,-
(play button)
Number
NOTE
• Manufacturers' codes are subject to change _\ithout notice.
• Set the codes again after rephtcing the batteries of the remote control.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer Code Manufacturer Code
JVC Ol Samsung 12
Hitachi 10 Sharp 06
Magnavox 02 Sony 07
Mitsubishi 03 Toshiba 08
Panasonic 04, 11 Zenith 09
RCA 05
Release ¢_1TV.
If there is more than one code listed ['er corresponding brand,
try each one until you enter the con'ect one.
• Operation
Aim the remote control tit the TV.
IMPORTANT
Bet'ore using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons _u'eavailable:
(b/I TV: Turns TV on and off.
TV VOL +1-: Adjusts the vohlme.
TWVIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +1-: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN: Alternates between the previously selected
channel and the curl'ent channel.
• To set the manufacturer's code
You can operate a JVC TV without setting the manufacturcr's code.
1 Slide the remote control mode selector
to TV.
2 Press and hold ¢/1TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
• Toset the manufacturer'scode
1 Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold ©/i VCR/DBS.
Keep the button pressed until step 5 is finished.
4
Press ENTER.
14