Configuring The Device - Siemens SIMATIC NET RUGGEDCOM RX1536 Equipment Manual

Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RX1536 console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RX1536 is
https://192.168.0.2.
For more information about available ports, refer to "Modules" (Page 27).
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RX1536 interface. For
more information about configuring the device, refer to the "RUGGEDCOM ROX II
Configuration Manual" associated with the installed software release.
RUGGEDCOM RX1536
Equipment Manual, 10/2023, C79000-G8976-1488-07
Pin Name
2
3
4
5
6
7
8
RX-
TX+
Reserved (Do Not Connect)
Reserved (Do Not Connect)
TX-
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Device Management
3.2 Configuring the Device
Description
Receive Data-
Transmit Data+
Transmit Data-
25