Table of Contents
Advertisement
OPERATING INSTRUCTIONS
USING THE INTERCOM DURING A
PHONE CALL
The HOLD feature allows you to put a
phone call on hold and use the inter-
com without disconnecting your caller.
It works at the handset or the base.
While you are on the call,
1.Press the INTERCOM key to auto-
matically place the active call on
hold, and to establish an intercom
call between the handset and base.
0
TONE
OPER
HOLD
PRV
PGM
MEM
2.To end the intercom conversation,
press OFF on the handset or INTER-
COM on the base unit.
3.To return to the call, press PHONE
or SPEAKERPHONE.
When the handset is paged from the
base while in-use, the handset will only
ring once.
TEMPORARY TONE FEATURE
If you have rotary(dial-pulse) telephone
service, (TONE/PULSE switch is set to
PULSE), this feature allows you to en-
ter special codes and tones to operate
answering machines, use electronic
banking services, calling cards, or other
special services.
To do this:
1.Dial the call normally.
This works on the Handset and the Base
Unit.
To end the call,press OFF (if calling from
the handset) or SPEAKERPHONE (if
calling from the base), or place the
handset back in the base. The phone
will automatically go back to rotary(dial-
INT.COM
pulse) service.
REDIAL
PAUSE
If you have touch-tone service, (TONE-
PULSE switch set to TONE), just enter
the codes normally.
PROGRAMMING THE RINGER TYPE
The VT 9141 cordless phone has four
different types of ringing tones. The
handset can have their ringer types
programmed independently by the fol-
lowing procedure.
To program, The handset must be OFF.
To select a different ringer type do the
following:
19
2.Activate the temporary tone feature
by pressing TONE (the
3.Press the numbers or symbols you
need, and your phone will send the
proper signals.
*
key).
Advertisement
Table of Contents
