Edit A Number/Name Stored In The Directory - VTech vt2498 Operating Instructions Manual

Phone Book Directory
* When you finish entering the name, press SELECT . The screen displays
* Enter the telephone number. Press
Press REDIAL/PAUSE to add a 2-second pause to the dialing sequence.
Multiple presses of the REDIAL/PAUSE key will increase the pause in two
second increments;
- OR -
To Save the Last Number Dialed:
Instead of entering the telephone number, press REDIAL/PAUSE to display the
last number dialed.
* Press SELECT . If you are programming at the Base, your number has been
stored.
* If you are programming the cordless Handset, the screen will display:
Yes will cause the cordless Handset to emit a different ring pattern if the number
you entered comes in via Caller ID (after the first ring).
* Press SELECT to confirm your choice. A Phone Book entry with Distinctive Ring
selected will display a D in the upper right corner of the screen.
NOTE: When phone book memory is full, any attempt to enter a new name/number
will generate an error tone and

Edit a Number/Name Stored in the Directory

* Press ( ).
* Press or to scroll for the desired entry;
- OR -
* Press the key that has the first letter of the name on the desired record. Press the
key again to scroll through all records in the letter range of that key. For example
the 5JKL key will cycle through all entries beginning with J, K, L and 5 ).
* With the desired name displayed, press SELECT . Press
flashes.
* Press SELECT .The cursor is now flashing at the end of the name. Use the
and dial keys to edit the name. Press SELECT .
* Now edit the phone number. When done, press SELECT . Now, make your
Distinctive Ring selection. Press SELECT to save your edits.
.
Use or
is displayed.
to backspace if you make a mistake.
key to choose Yes or No. Choosing
on the display.
or until
,