Page 1
Introduction IMPORTANT: The 2603 is an Accessory Handset for use with the 2652 system. You must have the 2652 in order to use the 2603 Accessory Handset. This manual is designed to familiarize you with the 2603 Accessory Handset setup, registration and basic functions.
Important Safety Instructions When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: Read and understand all instructions. Follow all warnings and instructions marked on the product.
Page 3
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. Do not use the telephone to report a gas leak in the vicinity of the leak. SAVE THESE INSTRUCTIONS 91-5576-10-00.p65...
Getting Started Your 2652 multi-handset system can operate up to 4 Handsets. The accessory Handset 2603 consists of the following: 91-5576-10-00.p65 Setup of the 2603 Accessory Handset Plug the AC power adapter into an electrical outlet. Plug the DC connector into the bottom of the Charger Unit.
Page 5
Registration Enter ID Code After charging the Handset, remove it from its Charge Cradle, the screen will display: Press NEW, then enter the 15 digit Base ID code, located on the underside of the 2652 Base Unit. Press OK. The Handset will display: PLEASE WAIT!! Wait approximately 15 seconds.
Base Unit. Handset LEDs Description Message Flashes to indicate that you have new messages in your voicemail. Service Waiting must be subscribed to through your local telephone company. 91-5576-10-00.p65 Handset Indicators 12 indicates that Handset 1 and 11/21/2003, 3:22 PM...
Additional Information Your 2603 cordless telephone is equipped with a 2.5mm Headset Jack for use with an optional accessory Headset for hands-free operation. If you choose to use the Headset option, you must obtain an optional accessory Headset, which is compatible with the 2603.
Avoid water Your telephone can be damaged if it gets wet. Do not use the Handset outdoors in the rain, or handle it with wet hands. Do not install your Base Unit near a sink, bathtub or shower.
First check all the suggestions above. • If you still don't hear a dial tone, disconnect the Base Unit from the telephone jack and connect a different phone. If there is no dial tone, the problem is in your wiring or local service.
You Hear Other Calls While Using Your Phone • Disconnect your Base Unit from the telephone jack, and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service. Call your local telephone company.
Limited Warranty The Supplier warrants, to the original purchaser only, the material and workmanship of this product for ONE YEAR from the date of purchase. The Supplier will repair or replace, at our option, this product without charge should it fail due to a defect in material or workmanship within that time period. This warranty does not apply to loss or damage that is the result of accident, misuse or negligence.
Should you experience trouble with this telephone equipment, please contact: Customer service at: 1-800-651-6791. For repair/warranty information, the telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected. FCC Part 15 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Page 14
The REN is used to determine how many devices you may connect to your telephone line and still have them ring when you are called. In most, but not all areas, the sum of all RENs should be five (5.0) or less. You may want to contact your local telephone company for more information.
Page 15
You will be given the opportunity to correct the problem and the telephone company is required to inform you of your right to file a complaint with the FCC. Your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the proper functioning of this product.
Page 16
Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, or electrician, as appropriate. Your telephone is designed to operate at the maximum power allowed by the FCC. This means your Handset and Base Unit can communicate only over a certain distance - which will depend on the location of the Base Unit and Handset, weather, and the construction and layout of your home or office.
Technical Specifications FREQUENCY CONTROL Crystal controlled PLL synthesizer TRANSMIT FREQUENCY 2401.056 - 2482.272 MHz RECEIVE FREQUENCY 2401.056 - 2482.272 MHz CHANNELS 95 Channels NOMINAL EFFECTIVE RANGE Maximum power allowed by FCC. Actual operating range may vary according to environmental conditions at the time of use. SIZE Handset: 176mm x 51mm x 41mm Charger: 68mm x 87mm x 58mm...