Ceiling Vent Fan; Cleaning Instructions; Exhaust Vent; Operation - Airstream BAMBI 2024 Owner's Manual

Ceiling Vent Fan

Review the vent fan manufacturer's instructions in your
owner's packet before operating, cleaning, or servicing
the fan� Follow the labeling on the fan to unlock, open,
and change fan settings as desired� Certain models
have a built-in safety switch that will not allow the motor
to operate unless the dome is open approximately 3
inches or more�
The high-volume ceiling vent exhausts stale hot air and
draws in fresh, clean air. To maximize airflow, close all
other vents and open the window or door furthest from
the vent fan�
NOTICE
For models with a locking knob, it may be
necessary to slightly rotate the knob to properly
align it to the lock. Do not use excessive force
when operating the locking knob.

Cleaning Instructions

CAUTION
Never operate the fan with the screen removed
and always disconnect power before cleaning or
servicing. Review the vent fan manufacturer's
cleaning instructions before cleaning or servicing
the fan.
To clean the screen, turn the fan motor and battery
disconnect switch OFF� The screen may be friction
held or have retainer clips that need turned halfway
to remove� Remove the screen and clean with a mild
soap and water solution� Carefully pat dry with a soft
cloth and reinstall�
NOTICE
The use of certain cleaners can cause cracking
and product failure. Review the vent fan
manufacturer's cleaning instructions before
cleaning or servicing the fan.
2024 Bambi

Exhaust Vent

Operation

The bath exhaust vent (shown above) removes
moisture from the air when using the shower� To
operate, you first need to open the vent.
To open the vent, push the button on the handle to
disengage the clip and slide the handle upward until
the clip engages� Once open, turn the fan on by
pressing the ON/OFF button�
Turn the fan OFF before closing the vent�
To close the vent, push the button on the handle to
disengage the clip and pull the handle down until the
clip engages in the lowered position�
NOTICE
Turn OFF the fan before closing the vent. Damage
to the motor can occur if the fan runs with the
vent closed.
Cleaning Instructions
CAUTION
Never operate the fan with the screen removed
and always disconnect power before cleaning or
servicing. Review the vent fan manufacturer's
cleaning instructions before cleaning or servicing
the fan.
To clean the screen, turn the fan motor and battery
disconnect switch OFF� Remove the four retainer
screws� Clean the screen with a mild soap and water
solution only�

Fuse Replacement

To change the 5 Amp fuse:
1� Make sure the fan is off�
2� Remove the cap by turning it to the left to gain
access�
3� Replace with a type GMA 5A fast-acting fuse�
4� Replace the cap to secure the fuse in the holder�
Interior
5-13