Cooktop; Ceiling Vent Fan; Thermostat And Rain Sensor; Cleaning Instructions - Airstream Trade Wind Owner's Manual

Table of Contents

Advertisement

Cooktop

There is little difference between the operation of
home gas ranges and the trailer's cooktop� However,
if you are only familiar with electric ranges, operating
confidence can be quickly gained by reading the
manufacturer's directions in your Airstream Owner's
Packet�
WARNING
An operation manual for the cooktop has been
provided with your owner's packet. If this has
not been provided with your trailer, contact the
listed manufacturer to obtain one. Their manual
contains specialized warnings and cautions
that should be reviewed prior to operating the
appliance.

Ceiling Vent Fan

Review the vent fan manufacturer's instructions in your
owner's packet before operating, cleaning, or servicing
the fan� Follow the labeling on the fan to unlock, open,
and change fan settings as desired� Certain models
have a built-in safety switch that will not allow the motor
to operate unless the dome is open approximately 3
inches or more�
The high-volume ceiling vent exhausts stale hot air and
draws in fresh, clean air. To maximize airflow, close all
other vents and open the window or door furthest from
the vent fan�
NOTICE
For models with a locking knob, it may be
necessary to slightly rotate the knob to properly
align it to the lock. Do not use excessive force
when operating the locking knob.
2024 Trade Wind

Thermostat and Rain Sensor

The fan is equipped with a built-in thermostat and rain
sensor� Select the thermostat setting and the fan will
automatically turn on and off as your trailer heats up
and cools down� When the rain sensor becomes wet
the dome will close automatically and shut the fan off�
Some models will automatically open and run once the
sensor is dry� Some models will beep when buttons are
pressed to indicate the sensor is wet and needs to dry
before operating�
NOTICE
If the lid is opened manually, the rain sensor will
not close the lid automatically. The sensor must
be dry for the fan to operate.

Cleaning Instructions

To clean the screen, turn the fan motor and battery
disconnect switch OFF� The screen may be friction
held or have retainer clips that need turned halfway
to remove� Remove the screen and clean with a mild
soap and water solution� Carefully pat dry with a soft
cloth and reinstall�
CAUTION
Never operate the fan with the screen removed
and always disconnect power before cleaning or
servicing. Review the vent fan manufacturer's
cleaning instructions before cleaning or servicing
the fan.
NOTICE
The use of certain cleaners can cause cracking
and product failure. Review the vent fan
manufacturer's cleaning instructions before
cleaning or servicing the fan.
Interior
5-21

Advertisement

Table of Contents
loading

Table of Contents