Advertisement
� If parts replacement is necessary, replace the parts with HYOSUNG Genuine Parts or their equivalent.
� When removing parts that are to be reused, keep them arranged in an orderly manner so that they may
be reinstalled in the proper order and orientation.
� Be sure to use special tools when instructed.
� Make sure that all parts used in reassembly are clean, and also lubricated when specified.
� When use of a certain type of lubricant, bond, or sealant is specified, be sure to use the specified type.
� When removing the battery, disconnect the negative cable first and then positive cable. When
reconnecting the battery, connect the positive cable first and then negative cable, and replace the terminal
cover on the positive terminal.
� When performing service to electrical parts, if the service procedures do not require use of
battery power, diconnect the negative cable at the battery.
� Tighten cylinder head and case bolts and nuts, beginning with larger diameter and ending with small-
er diameter, from inside to outside diagonally, to the specified tightening torque.
� Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, cotter pins, circlips,
and certain other parts as specified, be sure to replace them with new ones. Also, before installing
these new parts, be sure to remove any left over material from the mating surfaces.
� Never reuse a circlip. When installing a new circlip, take care not to expand the end gap larger
than required to slip the circlip over the shaft. After installing a circlip, always ensure that it is com-
pletely seated in its groove and securely fitted.
� Do not use self-locking nuts a few times over.
� Use a torque wrench to tighten fasteners to the torque values when specified. Wipe off grease or
oil if a thread is smeared with them.
� After reassembly, check parts for tightness and operation.
� To protect environment, do not unlawfully dispose of used motor oil and other fluids: batteries, and tires.
� To protect Earth' s natural resouces, properly dispose of used vehicles and parts.
WARNING
WARNING
GENERAL INFORMATION 1-2
Advertisement
