Table of Contents
Advertisement
SECTION III
SRA 400 STEREO POWER AMPLIFER
SOUND SYSTEM CONNECTIONS
FIGURE 9 — Bridged Output Connection
PRELIMINARY OPERATING SEQUENCE
1. Connect the sound system required for your
specific application. (See Sound System Connec¬
tions.)
2. Plug in line cord of the SRA 400. Do NOT remove
the grounding prong on the AC plug, it prevents
hum and possible shock. If necessary, use a
three-prong to two-prong adapter.
3. Turn on the sound system's mixer, and any other
equipment BEFORE turning on the SRA 400. This
will prevent possible speaker damage caused by
transients from the other equipment.
4. Turn the power switch on (Fig. 1 - Item 2). The
switch's internal lamp will light up, and the fan will
begin to operate.
5. Set both input attenuators to 0 VU CAL, or as
required for your sound system.
6. Adjust mixer output until a suitable listening level
is achieved, or until the red LEDs on the SRA 400
bar graph displays begin to flicker.
8
Advertisement
Table of Contents
