Table of Contents
Advertisement
en Shelf supports
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never hang combustible objects, e.g. tea towels, on
▶
the door handle.
Leave the front of the appliance clear.
▶
Keep children at a safe distance.
▶
If the door seal is damaged, a large amount of heat is
generated around the door.
Do not scrub or remove the seal.
▶
Never operate the appliance if the seal is damaged
▶
or missing.
Remove accessories and cookware from the cook-
1.
ing compartment.
Unhook the shelf supports and remove them from
2.
the cooking compartment.
→ "Shelf supports", Page 18
Remove heavy soiling from the cooking compart-
3.
ment.
Use a detergent solution and a soft cloth to clean
4.
the surfaces at the edges of the cooking compart-
ment around the door seal.
Do not remove or scrub the door seal.
Use oven cleaner to remove stubborn dirt from the
inner door pane.
Remove any objects from the cooking compartment.
5.
The cooking compartment must be empty.
14.2 Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of harm to health!
The cleaning function heats up the cooking compart-
ment to a very high temperature so that food left over
from roasting, grilling and baking will burn off. This pro-
cess releases vapours, which can irritate mucous mem-
branes.
Keep the kitchen well ventilated while the cleaning
▶
function is running.
Do not remain in the room for long periods.
▶
Keep children and pets away.
▶
WARNING ‒ Risk of burns!
The cooking compartment gets very hot when the
cleaning function is in progress.
Never open the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Shelf supports
15 Shelf supports
To clean the rails and the cooking compartment, or to
replace the rails, you can remove these.
18
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
▶
Allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Note: The oven light does not light up while the clean-
ing function is running.
Requirement: Prepare the appliance for the cleaning
function. → Page 17
Use the function selector to set Pyrolytic self-clean-
1.
ing .
Use the temperature selector to set the cleaning set-
2.
ting.
Cleaning set-
Cleaning
ting
level
1
Low
2
Medium
3
High
Select a higher cleaning setting if the cooking com-
partment is particularly dirty or has not been
cleaned for a while.
The duration cannot be changed.
a After a few seconds, the cleaning function starts and
the duration counts down.
a For your safety, the appliance door locks once a
certain temperature is reached in the cooking com-
partment. appears on the display.
a When the cleaning function ends, a signal tone
sounds and the duration is at zero on the display.
Switch off the appliance.
3.
When the appliance has cooled down sufficiently,
the appliance door is unlocked and goes out.
Prepare the appliance for use. → Page 18
4.
14.3 Preparing the appliance for use
following the cleaning function
Allow the appliance to cool down.
1.
Wipe off any ash that has been left behind in the
2.
cooking compartment and around the appliance
door with a damp cloth.
Remove white residues with lemon juice.
3.
Note: White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
Attach the shelf supports.
4.
→ "Shelf supports", Page 18
15.1 Detaching the shelf supports
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
▶
Lift the rail forwards slightly
1.
Duration in hours
Approx. 1:15
Approx. 1:30
Approx. 2:00
and detach it
.
Advertisement
Table of Contents
