Advertisement
Available languages
Available languages
en Operating the mopping nozzle
Runtime
Mode 3 up to min.
Mode 4 up to min.
Notes
¡ Like every Li-ion battery, the batteries
from the Power for ALL 18 V series wear
out over time, meaning that the battery
capacity and the runtime decrease. This
is a natural aging process and not the
result of a material error, manufacturing
error or material defect.
¡ You can delay the natural wear by using
the following measures:
– Only charge the battery in the temper-
ature range between 0 °C and 45 °C.
– Only store the battery in the temperat-
ure range between -20 °C and 50 °C.
– Do not store the battery for an exten-
ded period of time if it is fully charged
or fully discharged.
Operating the appliance
11
24
→ Fig.
-
Removing the appliance
→ Fig.
25
-
27
noz z l e
moppi n g
t h e
Ope r a t i n g
Operating the mopping nozzle
noz z l e
moppi n g
t h e
Ope r a t i n g
Filling the water tank
▶ Do not fill with hot water above 50 °C.
▶ Dose cleaning additives according to the
manufacturer's instructions.
▶ Do not use wax, oils or cleaning addit-
ives that cannot be diluted with water.
▶ Do not use any non-transparent, milky,
chlorinated, acidic and foaming cleaning
additives (e.g. dishwasher detergent).
▶ Only use neutral multi-purpose cleaning
agents.
▶ Close the filling lid completely before in-
serting the water tank.
▶ Wipe up any residual water on the water
tank with an absorbent cloth.
28
33
→ Fig.
-
24
3,0 Ah
15
10
Attaching the mopping pads
▶ When the appliance is switched on, do
not attach the mopping pads.
→ Fig.
34
-
35
Using the nozzle
▶ Do not leave the appliance in one posi-
tion for more than 1 minute with the
nozzle and wet mopping pads attached,
regardless of whether the appliance is
switched on or off.
Tip: Use the automatic mode for the best
mopping results and a longer run time.
→ Fig.
36
-
39
Activating the water boost function
Tip: Use the water boost function to
moisten dry mopping pads more quickly or
to remove particularly stubborn stains.
▶
Press and hold
→ Fig.
40
a The LED status indicator flashes slowly.
a The water boost function is activated.
Note: The water boost stops automatically
after 30 seconds. The automatic water sup-
ply is then activated again.
s e r v i c i n g
a nd
Cl e a ni n g
Cleaning and servicing
To keep your appliance working efficiently
s e r v i c i n g
a nd
Cl e a ni n g
for a long time, it is important to clean and
maintain it carefully.
Cleaning the appliance
41
41
→ Fig.
-
Emptying the dust container
→ Fig.
42
-
45
Cleaning the filter unit
Note: It is recommended cleaning the filter
of the dust container whenever you empty
the container. It should however be done at
least once a month.
▶ Never allow the filters to come into con-
tact with liquids.
46
52
→ Fig.
-
Cleaning the floor nozzle
→ Fig.
53
-
53
for at least 3 seconds.
Advertisement
