uuIndicatorsu
Indicator
Name
Supplemental
Restraint System
Indicator
Auto High-Beam
Indicator
Vehicle Stability
Assist
TM
System Indicator
*1:Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
84
On/Blinking
●
Comes on for a few seconds when
you turn the ignition switch to ON
(
w
*1
, then goes off.
Comes on if a problem with any of
●
the following is detected:
- Supplemental restraint system
- Side airbag system
- Side curtain airbag system
- Seat belt tensioner
• Comes on when all the operating
conditions of the auto high-beam
are met.
Comes on for a few seconds when
●
you turn the ignition switch to ON
(
w
*1
, then goes off.
Blinks when VSA® is active.
●
Comes on if there is a problem
●
with the VSA® or hill start assist
(VSA®)
system.
Comes on if the VSA® system is
●
deactivated temporarily after the
battery has been disconnected,
then re-connected.
Explanation
●
Stays on constantly or does not come
on at all - Have your vehicle checked by
a dealer.
2 Auto High-Beam P. 162
Stays on constantly - Have your vehicle
●
checked by a dealer.
2 Vehicle Stability Assist
Electronic Stability Control (ESC),
System P. 439
Drive a short distance at more than 12
●
mph (20 km/h). The indicator should go
off. If it does not, have your vehicle
checked by a dealer.
Message
—
TM
(VSA®), aka