Olympus CAMEDIA C-7070wz Advanced Manual page 181

Possible cause
Halation produces unnatural colors in the picture.
This may be caused by
excessively bright
ultraviolet light on the
subject, such as sunlight
shining through the
leaves of trees, window
frames in bright light at
night, reflection of metal
in direct sunlight, etc.
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures on
the card.
There is a problem with
the card.
The camera is
connected to a TV.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
The TV video signal
setting is incorrect.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Corrective action
Use an Olympus UV filter. As this may upset
the overall color balance, it should only be
used in the conditions described on the left.
If the discoloration persists, touch up the
picture using a graphics application. For
details, refer to the manual for the graphics
application you are using.
Set the mode dial to q, then turn the power
switch to ON.
Press the QUICK VIEW button or set the
mode dial to q.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error codes".
The monitor does not function when the AV
cable is connected to the camera.
Display pictures with 9 and press the 0
button to cancel protection.
Set the video output signal according to the
region where used.
Set the TV to the video input mode.
Select [s] in [MODE MENU] and adjust the
brightness.
Block the sunlight with your hand or use the
viewfinder.
Troubleshooting
Ref.
page
–
P. 13
P. 13,
16
–
P. 174
P. 112
P. 115
P. 113
P. 112
P. 130
–
181
10