Self-Timer; Flash Modes; Power Save Feature - Olympus MJU-1000 Basic Manual

Press 2Y.
1
Press 12 to select [Y ON], and press o.
2
3
Press the shutter button fully to take the picture.
The self-timer lamp lights for approximately 10
seconds after the shutter button is pressed, then
starts blinking. After blinking for approximately 2
seconds, the picture is taken.

Flash Modes

Press 3#.
1
Press 12 to select the flash mode, and press o.
2
3
Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4
Press the shutter button completely to take the picture.
Icon Flash Mode
Auto flash
No
indication
Red-eye
!
reduction flash
# Fill-in flash
$
Flash off

Power Save Feature

To save battery power, the camera automatically enters sleep mode and stops
operating if not used for 3 minutes in shooting mode. Press the shutter button
or zoom button to reactivate the camera.
If the camera is not operated for 15 minutes after the camera enters sleep
mode, it automatically retracts the lens and turns off. To resume operation, turn
on the power again.
If the camera has been used for a long time, the internal temperature of the
camera may rise, stopping the operation automatically. In such a case, remove
the battery from the camera and leave the camera until it becomes cool. The
camera outside temperature may also rise during operation, but it is not a
trouble.

Self-Timer

The flash fires automatically in low light or backlight
conditions.
This emits pre-flashes to reduce the occurrence of red-
eye in your pictures.
The flash fires regardless of the available light.
The flash does not fire even in low light conditions.
Self-Timer Lamp
Description
En
13