Table of Contents
Advertisement
Before using for the first time
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Performing initial start-up
After connecting the appliance to the power supply,
you must configure the settings for its initial start-up. It
may take a few minutes for the settings to appear on
the display.
Press
to switch the appliance on.
1.
a The first setting appears.
To change the setting as required, press a value in
2.
the list or change the value using the setting ring.
Possible settings:
– Language
– Home Connect → "Home Connect ", Page 17
– Time
→ "Setting the time", Page 17
Press
and switch to the next setting.
3.
Work through the settings and make changes as re-
4.
quired.
a After the last setting, a message appears on the dis-
play confirming that the initial start-up is complete.
To check the appliance before heating for the first
5.
time, open and close the appliance door once.
Basic operation
8 Basic operation
8.1 Switching on the appliance
Press
to switch the appliance on.
▶
a The display shows the menu.
8.2 Switching off the appliance
Switch your appliance off when you are not using it.
The appliance will switch itself off automatically if it is
not used for a certain period of time.
Press
to switch the appliance off.
▶
a The appliance switches off. Any functions currently
in progress are cancelled.
a The time or residual heat indicator appears on the
display.
8.3 Starting the operation
You must start each operation.
Before using for the first time en
7.2 Cleaning the appliance before using it
for the first time
Before using the appliance to cook food for the first
time, you must clean the cooking compartment and ac-
cessories.
Remove the product information and the accessor-
1.
ies from the cooking compartment. Remove any
leftover packaging, such as polystyrene pellets, and
any adhesive tape that is in or on the appliance.
Wipe the smooth surfaces in the cooking compart-
2.
ment with a soft, damp cloth.
Press
to switch the appliance on.
3.
Apply the following settings:
4.
Type of heating
Temperature
Cooking time
→ "Basic operation", Page 11
Start the operation.
5.
Ventilate the kitchen while the appliance is heat-
‒
ing.
a When the time has elapsed, a signal sounds. A
message appears on the display confirming that the
operation has finished.
Press
to switch the appliance off.
6.
Once the appliance has cooled down, clean the
7.
smooth surfaces in the cooking compartment with a
detergent solution and a dish cloth.
Clean the accessories thoroughly using a detergent
8.
solution and a dish cloth or soft brush.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120 °C, this will damage the enamel.
Do not use the appliance if there is water on the
▶
cooking compartment floor.
Wipe away any water on the cooking compartment
▶
floor before operation.
Press
to start the operation.
▶
a The settings appear on the display.
8.4 Interrupting the operation
You can interrupt the operation and then continue
again.
To interrupt the operation, press
1.
Press
again to resume the operation.
2.
8.5 Setting the operating mode
After you have switched on the appliance, the menu
appears on the display.
To scroll through the various selection options,
1.
swipe to the left or right on the display.
Swipe right or left to scroll through the menu and
‒
other setting options.
2D hot air
Maximum
1 hour
.
11
Advertisement
Table of Contents
