Husqvarna AUTOMOWER 435X AWD Operator's Manual page 17

CAUTION: Do not let the product
operate on gravel.
• If you make an island, put the boundary wire
that runs to and from the island near
together (E). Put the wires in the same
stake.
• Make an eyelet (F) where the guide wire is
to be connected to the boundary wire.
CAUTION: Do not make sharp
bends when you install the
boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
3.2.3.1 To put the boundary wire in a slope
> 1.5 m / 5 ft
0% - 50%
• For slopes up to 50% steep inside the work
area, the product will operate normally.
Keep a distance of 1.5 m / 5 ft between the
boundary wire and obstacles, or between
obstacles.
• For slopes between 50-70% steep, make
sure that there are no obstacles in the slope.
There must be a distance of 1.5 m / 5 ft from
the bottom of the slope to the boundary wire.
• For slopes adjacent to a public road, put a
fence or a protective wall along the outer
edge of the slope.
3.2.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 work areas. The
1035 - 001 - 04.02.2019
> 1.5 m / 5 ft
> 1.5 m / 5 ft
50% - 70%
passage must be a minimum of 60 cm / 24 in.
wide.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
A dead end must be a minimum of 2.5 m / 8.5 ft.
wide.
>60 cm / 12"
Note: Make sure that the guide wire has as much
free area as possible to the left of the guide wire
when facing the charging station. Minimum
distance between the guide wire and boundary
wire is 30 cm / 12 in.
3.2.3.3 To make an island
• Put the boundary wire to and around the
obstacle to make an island.
• Put the 2 sections of boundary wire that run
to and from the obstacle together.
>2 m / 7 ft
>2.5 m / 8.5 ft
Max.
distance
>30 cm / 12"
>2 m / 7 ft
Installation - 17