Connecting The Antennas; Connecting The Ac Adapter; Installing New Batteries - VocoPro UHF-6800 Owner's Manual

Getting started cont.

Connecting the Antennas

1. Screw on each antennae to the BNC connectors on the front of the UHF-6800. Twist clockwise until it is secure.
Antennas

Connecting the AC adapter

Caution: Before connecting the power supply, make sure that the power switch on the reciever is switched OFF.
Note: For additional protection, it is recommended that you plug in the power supply to a surge protector/Power strip.
1. Connect the output end to the AC Power input on the rear panel of the UHF-6800.
2. Connect the AC adapter to a power outlet.
NOTE: It is recommended that you connect to a power strip/surge-protector for added protection.

Installing New Batteries

NOTE: The UHF-6800 requires 2 AA rechargeable batteries.
To install:
1. Slide off the battery compartment cover completely until the battery slots are exposed (Fig. A).
2. Insert both batteries and make sure that their polarities are facing the proper direction (Fig. B).
3. Reattach the battery compartment cover by sliding it back on until it is secure again.
Batteries
Fig. A
8
Fig. B