Table of Contents
Advertisement
Mounting
To install the UHF-5805 to a 19" rack case, complete the steps below.
1. Attach mounting brackets to the UHF-5805 via the supplied mounting screws.
2. Align the UHF-5805 with the desired space in rack and slowly slide in, rear panel first.
NOTE: Depending on your rack case design, it may be neces-
sary to allow for sufficient space for the antennas.
3. While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-5805 in
its space, using the "X" rotation (numbered below) will ensure even tension and flush alignment.
NOTE: Do not tighten screws firmly until all screws are in place.
�
�
�
�
9
Hide quick links:
Advertisement
Table of Contents
