IBM X 330 Series Installation Manual page 20

9. Connect the internal cables to the adapter.
8
IBM xSeries 330 Type 8675: Installation Guide
Retention
latch
b. Carefully grasp the adapter by its top edge or upper corners, and align it with
the connector on the PCI riser card.
c. Press the adapter firmly into the riser-card connector.
Attention: When you install an adapter, be sure that the adapter is correctly
seated in the riser-card connector before you turn on the server. Improperly
seated adapters might cause damage to the system board, the riser card, or
the adapter.
d. If you opened the adapter-retention latch in step 8a, push down on the latch
now until it clicks into place, securing the adapter. Otherwise, proceed with
the next step.
e. Replace the expansion-slot clip by sliding it down until it latches into place
and holds the adapter securely.
Attention: Route cables so that they do not block the flow of air from the fans.
PCI riser card
Adapter
Tab
Expansion
slot clip
Expansion
slot