Samsung SCP-3120VH User Manual page 90

Troubleshooting
The camera's position
differs from the position
defined in a preset.
Sequence configuration of
the camera does not work.
The upper side of the
picture is dark when the
camera is on the horizontal
reference point.
Camera suddenly turns on
or moves to a preset
position by itself.
• The Power cord's coating
has been damaged.
• The power cord is hot to
touch when the product is
in operation.
• The power cord gets hot
after being folded or
pulled on.
This phenomenon may happen, since the
motors have a margin error of ±0.1˚.
Check if Preset or another operation mode
has been set.
Check the Auto Refresh settings.
You are seeing the camera's internal
cover. The camera is functioning normally.
Check the Auto Run settings.
Auto Run puts a camera through a predefined
action sequence if the user does not use the
Controller to operate the camera for a certain
period of time.
Continuing to use the product when its power
cord is damaged constitutes an electrical and
fire hazard. The power plug must be removed
from the outlet immediately, and a qualified
service personnel or your system provider
should be contacted for assistance.
90
SPEED DOME CAMERA User Guide
-
58~62
85
-
67
-