Introduction; Purpose; Scope Of Liability; Regulations - Solahart Solahart475DH1 Installation Manual

Introduction

1
We appreciate for your trust and confidence towards the
photovoltaic (PV) module products from Solahart.
Please read all instructions and the electrical and
mechanical requirements in this manual carefully
before installation. Specialized skills are required for
installing and operating PV modules, and only
professionals are capable to perform this task. All safety
precautions in this manual shall be strictly observed
during installation, and the manual shall be properly
kept for further reference. The installer must inform the
end customer (or consumer) accordingly.

1.1 Purpose

This document provides detailed instructions and safety
precautions regarding the installation, electrical
connection, and maintenance of following Solahart
SunCell-Plus PV modules :
Solahart475DH1 Solahart480DH1

1.2 Scope of liability

No warranty expressed or implied is made with regard
3
to any information in this manual because how this
manual is complied with is beyond the control of
Solahart. Solahart shall not be liable for any form of
loss, including but not limited to loss, damage, casualty
or additional cost caused by improper installation,
operation, use and maintenance of PV modules and
systems.
Solahart reserves the right to update this manual without
prior notice.
2

Regulations

The mechanical installation and electrical connection
of PV systems should be performed in accordance with
local laws, regulations and corresponding international
and domestic standards including electrical codes,
building codes and electrical connection requirements.
Such requirements may vary from different mounting
location, e.g. rooftop system and floating systems.
Requirements may also vary with system voltage and
for DC/AC applications. Please contact
authorities for detailed governing regulations.
3

Safety Precautions

 Solahart SunCell modules are designed to meet the
requirements of IEC61215 and IEC61730, and they
have been qualified for Application Class A
(equivalent to Safety Class II requirements).
Modules can be applied to publicly accessible
systems operating at greater than 50V DC or 240W.
local