Table of Contents
Advertisement
Operation for components connected to the TAPE 2/ADAPTOR jacks
Before operating a component connected to the TAPE 2/
ADAPTOR jacks, be sure to set the TAPE 2 /ADAPTOR
selector on the rear panel.
Fora component other
illil
I
For the surround
than the surround
processor SS-992 01
processor SS-992 or
TAPE 2
ADAPTOR
SS-592
SS-592
Set this selector only when the power is turned off.
TAPE 2/ADAPTOR key
VOLUME CONTROL knob
■ Using the surround processor SS-992 or SS-592
By connecting the SS-992 or SS-592 with a system control cord, the remote control unit supplied with this unit can control
it.
A
I
Press the TAPE 2/ADAPTOR key so that the
3 Adiust the entire volume level.
ADAPTOR indicator lights.
The entire volume level can be adjusted with the
tape a/
volume control of the surround processor or the
ADAPTOR
VOLUME CONTROL keys on the remote control unit.
The VOLU ME CONTROL knob is automatically set to the center
position in about 20 seconds.
VOLUME CONTROL
When the surround processor is not used
Press the TAPE 2/ADAPTOR key again.
The ADAPTOR
indicator goes off.-
2 Adjust the level of the surround sound.
r^~i r^i
I
DELAY
rear
TIME
LEVEL
[ ^
1
( ^
1
For details, refer to the instruction manual supplied with the
surround processor.
The VOLUME CONTROL knob of this unit is automatically set to
the minimum position in about 20 seconds.
Notes:
1. When using a component other than the SS-992 or SS-592, be sure
to set the TAPE 2/ADAPTOR selector on the rear panel to the TAPE
2 position.
2. When the TAPE 2/ADAPTOR key is turned on, the synchronized
recording cannot be carried out.
■ Using a component other than the surround processor SS-992 or SS-592
When the TAPE 2/ADAPTOR key is set to the TAPE 2 position, the component connected to the TAPE 2/ADAPTOR jacks
will be played regardless of the setting of the INPUT SELECTOR knob. It is advisable to connect a cassette deck.
The optional remote control unit (RC-190) can not only be used as the system remote control unit of KENWOOD system
components, but also as a"learning"remote control which allows to program the remote control signals of other components
and operate various components from a single remote control unit.
1. The remote control keys can be used in three ways according to the setting of the MODE switch. The majority of the key functions in the AUDIO
mode and some of those in the VIDEO mode are the original codes preset at the factory for use in operating KENWOOD components.
CM\A/nnr
Advertisement
Table of Contents
